 | PASSABLENESS
OF THE CAR |  |
After check at the stand the distributor
of ignition removed from the engine is necessary for establishing
as follows:
To uncover the distributor, to check up and adjust a backlash between
breaker contacts;
To turn a cranked shaft prior to the beginning of a compression
step in the first cylinder, and then, continuing to turn a cranked
shaft, to combine a label 1 with a label 3;
To turn a rotor in such position at which its external contact will
be directed towards contact of the first cylinder on a distributor
cover;
Keeping a shaft of the distributor from , to insert it into a nest
on the block of cylinders so that there was a coupling of the platen
with a gear wheel;
To fix the distributor on the block of cylinders;
To establish a cover, to attach wires;
To check up and adjust installation of the moment of ignition.
Check and backlash adjustment between breaker contacts.
For backlash check it is necessary:
To turn the platen of the distributor before position when the textolite
pillow ise on a ledge of a side of a cam, thus the backlash between
contacts will be the greatest;
To check up a backlash between contacts and if necessary to adjust
it.
If a backlash wrong, on engines VAZ-2105 and VAZ-2106 it is necessary
to weaken the lock screw, to establish in a groove a screw-driver
and to move a platform with motionless contact of the breaker. After
installation of a necessary backlash the lock screw tighten.
 |  |  |
| Dirt road | Snow-covered
road | Mountain road |
|