PASSABLENESS OF THE CAR

If noise and knocks at coupling inclusion is audible.
Causes of defect can be:
Deterioration of details fluctuations;
Deterioration of windows under springs fluctuations in a conducted disk, a nave and a plate ;
Strong a deposit or breakage of springs fluctuations;
Deformation of a conducted disk;
Considerable or non-uniform deterioration naves of a conducted disk or a primary shaft of a transmission;
Deterioration of the forward bearing of a primary shaft of a transmission.
At deterioration of details - to replace a conducted disk.
At deterioration of windows under springs fluctuations in a conducted disk - to replace a conducted disk.
At considerable a deposit or spring breakage - to replace a conducted disk.
At deformation of a conducted disk - to correct a disk or to replace its new.
At deterioration naves of a conducted disk or a primary shaft of a transmission - to replace a conducted disk and if it is necessary, a primary shaft of a transmission.
At deterioration of the forward bearing of a primary shaft of a transmission - to replace the bearing.
If noise at coupling deenergizing possible causes of defect can be deterioration, damage or leak of lubricant from the bearing of deenergizing of coupling is listened. In this case the bearing replace new.
At repair of details and knots couplings do not separate with the block of cylinders not to break an aligning aperture concerning radical support of a cranked shaft. In the presence of the cracks passing through aligning aperture, a detail replace. Small cracks on the loaded surfaces eliminate electroarc welding, and on the surfaces which are not bearing loadings, small cracks eliminate synthetic materials on a basis pitches. The worn out apertures increase on diameter, the plug and develop it till the working size. Deterioration of an aperture under a starter eliminate statement of an additional repair detail or with the subsequent apertures towards the size. Conducted disks at repair assort completely. Priklepannye overlays if necessary separate, drilling or cutting off overlays. After repair a conducted disk collect, or paste to it frictional overlays. After assemblage disks balance.